null Skip to main content

Bexar Arms Wolf-3 M16 9310 5.56 Bolt Carrier Group - Black Nitride

Bexar Arms

MSRP: $179.99
Our Price: $159.99
(You save $20.00 )
(No reviews yet) Write a Review
SKU:
WOLF3-M16-BCG-556-9310-SBN

Out of Stock

The assault on Irontown draws near.. Are you ready, Wolf-3?

Limited run of the Wolf-3 battle mask logo. These BCG's are otherwise identical to our standard BCG's.

As the main reciprocating component of the action, the Bolt Carrier Group is critical to the reliable function of your AR-15 or M16.

We take extreme care in making sure our BCG's are of the best quality possible for the most reliable function possible. Each BCG is individually gauged and inspected to ensure that all tolerances are met and exceeded. Because we gauge each BCG individually and hold extremely tight tolerances, we've chosen to use Helical Gas Rings for a more complete seal between the carrier and the bolt. Other manufacturers use carriers that were spec'd for chrome lining for their nitride carriers as well which leads to loose gas ring chambers, bolt tail seals, and bolt shoulder supports. We spec our nitrided carriers specifically to be nitrided, so our gas ring chamber, bolt tail seal, and bolt shoulder support is toleranced to account for the lack of a thick buildup of chrome. Our BCG will never fail the "gas ring test" with our Helical Gas Rings when new, guaranteed.

We install and dimple stake our gas keys in house to ensure that the gas key screws are torqued correctly, that the bottom of the gas key is flat, and that there's sealant used between the gas key and the carrier. We use OCKS screws for their improved design that accepts staking better than MilSpec screws which increase their resistance to backing out under harsh conditions. Permatex 27010 "Red Gel" is used to seal the gas key to the carrier as well as on the OCKS gas key screw threads to further resist loosening unintentionally.

All of these small improvements and attention to detail culminates into a BCG that is ready for anything you can put it through. If you're serious about quality, our BCG will not disappoint!

Features:

  • Individually Gauged and Inspected In House
  • Machined and Toleranced Specifically to be Nitrided
  • Compatible with 5.56, .223, 300 Blackout, 350 Legend, etc.
  • 9310 Bolt
    • Black Nitrided
    • Shot Peened, Properly Heat Treated, and MPI Inspected
    • Inconel X750 Extractor Spring
    • Inconel X750 Ejector Spring
  • Billet Extractor
    • Billet 4140 Steel
    • Phosphated
    • Extractor Viton O-Ring included
  • 8620 Carrier
    • Back Nitrided
    • Full Auto M16 Profile
  • 4140 Billet Gas Key
    • Black Nitrided
    • Sealed to Carrier with Permatex 27010 "Red Gel"
    • "Decked" before Installation
    • Dimple Staked In House with OCKS Screws
  • 4140 Billet Cam Pin
    • Black Nitrided
  • Enhanced Helical Gas Rings
    • We have been made aware of an occasional issue with some helical gas rings becoming sticky after shooting. For the time being, all BCG's will come with standard gas rings while we resolve this issue.
    • Guaranteed to pass the "Gas Ring Test" with our Carriers
  • Mil-Spec Firing Pin
    • Swiss Turned from 8640 Steel
    • Hard Chrome Plated
  • 100% Made in USA