As the main reciprocating component of the action, the Bolt Carrier Group is critical to the reliable function of your AR-15 or M16.
We take extreme care in making sure our BCG's are of the best quality possible for the most reliable function possible. Each BCG is individually gauged and inspected to ensure that all tolerances are met and exceeded. Because we gauge each BCG individually and hold extremely tight tolerances, we've chosen to use Helical Gas Rings for a more complete seal between the carrier and the bolt. Other manufacturers use carriers that were spec'd for chrome lining for their nitride carriers as well which leads to loose gas ring chambers, bolt tail seals, and bolt shoulder supports. We spec our nitrided carriers specifically to be nitrided, so our gas ring chamber, bolt tail seal, and bolt shoulder support is toleranced to account for the lack of a thick buildup of chrome. Our BCG will never fail the "gas ring test" with our Helical Gas Rings when new, guaranteed.
We install and dimple stake our gas keys in house to ensure that the gas key screws are torqued correctly, that the bottom of the gas key is flat, and that there's sealant used between the gas key and the carrier. We use OCKS screws for their improved design that accepts staking better than MilSpec screws which increase their resistance to backing out under harsh conditions. Permatex 27010 "Red Gel" is used to seal the gas key to the carrier as well as on the OCKS gas key screw threads to further resist loosening unintentionally.
All of these small improvements and attention to detail culminates into a BCG that is ready for anything you can put it through. If you're serious about quality, our BCG will not disappoint!
- Individually Gauged and Inspected In House
- Machined and Toleranced Specifically to be Nitrided
- Compatible with 5.56, .223, 300 Blackout, 350 Legend, etc.
- 9310 Bolt
- Black Nitrided
- Shot Peened, Properly Heat Treated, and MPI Inspected
- Inconel X750 Extractor Spring
- Inconel X750 Ejector Spring
- Billet Extractor
- Billet 4140 Steel
- Extractor Viton O-Ring included
- 8620 Carrier
- Back Nitrided
- Full Auto M16 Profile
- 4140 Billet Gas Key
- Black Nitrided
- Sealed to Carrier with Permatex 27010 "Red Gel"
- "Decked" before Installation
- Dimple Staked In House with OCKS Screws
- 4140 Billet Cam Pin
- Black Nitrided
- Enhanced Helical Gas Rings
- Guaranteed to pass the "Gas Ring Test" with our Carriers
- Mil-Spec Firing Pin
- Swiss Turned from 8640 Steel
- Hard Chrome Plated
- 100% Made in USA
2 Reviews Hide Reviews Show Reviews
This bcg is going to be my go to from now on. Finish is absolutely perfect, OCK’s screws, and attention to detail like flatting the gas key to help ensure a sealed carrier. Flawless.
After receiving and looking over this BCG carefully, it’s among my favorites. Previously the only BCG I’d use was Sionics and I’d rank this Bexar Arms right up there at the top of my favorites list now. I love the attention to detail, the OCKS screws, the beautiful staking, the finish is the nicest nitride I’ve seen on any part. The machine work is great and I find comfort in knowing that Bexar Arms has gauged them and inspected them so throughly, sealed the gas key, used good springs, etc to ensure it’s the using all the best components and assembly techniques.